Valuable Guide to Understanding Using Custom Towbars

 

Australia is indeed a bold, daring, and adventurous land. That is why Australians are always prepared in leaving their homes and driving to the nearest desert, beach, and other places wherein they will enjoy nature. Truly, life in Australia is unsurprisingly beautiful. If you like it traveling more, you just have to have a car, SUV, van, and truck. This will also bring your family safe anywhere in Australia. But then, you must have with you a quality set of custom towbars Toowoomba.

 

Below is a more valuable guide to understanding using custom towbars Toowoomba.

 

Park the Car First on a Levelled Surface

Start to park the car on a leveled and flat surface with lots of space. This will pull the vehicle to be towed up behind it. Then, place it in a park while you apply the emergency brake. Ensure the base plate and hitch heights fall within three inches. Verify the base plate attachment tabs’ height next to the RV’s receiver hitch height. There must never be a three-inch difference in this case.

 

Mount Custom Towbars in the RV

Insert the shank of the tow bar into the RV hitch’ receiver and secure it using a clip and hitch. Other tow bars have 2 or even more pin holes in a shank. This allows more clearance as needed. Use the tow bar in a short time as recommended. Fold the custom tow bars in Toowoomba up and outside the way as possible. This will help avoid vehicle obstruction.

 

Park the Vehicle At the Back of the RV

Drive the vehicle up at the back of your RV. This will ensure the vehicles go in parallel with each other. If the vehicle is dinghy in its towing position, place the car in the park. Then, apply an emergency brake. Be extra careful not to drive into a tow bar. Seek help from a friend who will take a look at the distance.

 

Attach the Custom Towbars Arms

Get the 2 attachment tabs inserted in the base plate receivers in the dinghy vehicle. Attach the arms of the tow bar to the attachment tabs. A lot of tow bars feature extending arms allowing ease of hookup in the tabs. Then, release the handles of the latch while you extend those arms. Secure the arm after it’s in position. Include as well the tab connections alongside lynchpins.

 

Get the Dinghy Vehicle Prepared for Towing

 

Unlock the steering wheel if you set the dinghy vehicle transmission for the towing. Read the manual so you can do the flat towing procedure. Place the vehicles in neutral. But, be sure to follow the manufacturer’s guidelines.

 

Let the Tow Bar Latches Engaged

Get the tow bar latches fully locked as the RV is pulled forward slowly. Release then a parking brake and put the RV in the drive. It will ease your foot from the brake. Once the tow bar arm latches engage, it will stop. Ensure the latches on the arms are locked securely in place before towing.

 

Get the Safety Cables Attached

Get the safety cables attached to the hitch safety loops of the RV and the base plate links of the dinghy vehicle. Criss-cross the cables and right under the tow bar. These cables must never drag on the ground as you tow.

 

Get the Wiring Harness Plugged

Let the dinghy vehicle plug into the RV’s electrical socket. There will always be a four-way type of flat socket. Get the plugs connected including the emergency breakaway. Equip the dinghy vehicle with the towing lights of the RV. Get the lighting function tested before towing it.

 

So, keep these tips in mind when using custom towbars Toowoomba!